LED
Symbol
Location
General Behavior
Link Service
Action Required
(Fault)
ESM canister
•
On – The cable is attached and at
least one lane has a link-up
status, but one lane has a link-
down status.
•
Off – The cable is not attached,
the cable is attached and all lanes
have a link-up status, or the cable
is attached and all lanes have a
link-down status.
Link Up
Two LEDs
above each
expansion
connector
ESM canister
•
On – The cable is attached and at
least one lane has a link-up
status.
•
Off – The cable is not attached,
or the cable is attached and all
lanes have a link-down status.
Things to know - Display sequence code definitions
During normal operation, the tray ID display on each controller canister shows the controller-drive
tray ID. The Diagnostic LED (lower-digit decimal point) comes on when the display is used for
diagnostic codes and goes off when the display is used to show the tray ID. The category code may
be followed by a dash + and a "CF" followed by one of the component location codes described in
Things to know - Lock-down codes
on page 129.
Table 34: Sequence code definitions
Category
Category
Code
1
Detail Codes
2
Startup error
SE+
3
•
88+ Power-on default
•
dF+ Power-on diagnostic fault
•
Sx Power-on validation error
Operational error
OE+
Lx+ Lock-down codes. (See
Things to know - Lock-down
codes
on page 129.)
Operational state
OS+
•
OL+ = Offline.
•
bb+ = Battery backup (operating on batteries).
•
OH + CPU temperature exceeds the warning level
•
CF+ = Component failure.
•
Sd+ = Start of Day (SOD) processing
Step 10 - Turning on the power and checking for problems in a controller-drive tray configuration | 127
Summary of Contents for E2760
Page 2: ......
