6. Repeat Step
3
through Step
5
to install all of the drives.
7. Slide the drawer back into the drive tray by pushing it from the center and closing both levers.
Attention:
Risk of equipment malfunction – Make sure to completely close the drive drawer
by pushing both levers. You must completely close the drive drawer to allow proper airflow and
prevent overheating.
8. Attach the bezel to the front of the drive tray.
Things to know - Connecting the power cords
•
For each AC power connector on the drive tray, make sure that you use a separate power source in
the cabinet. Connecting to independent power sources maintains power redundancy.
•
To ensure proper cooling and ensure availability, the drive tray always uses two power supplies.
•
You can use the power cords shipped with the drive tray with typical outlets used in the
destination country, such as a wall receptacle or an uninterrupted power supply (UPS). These
power cords, however, are not intended for use in most EIA-compliant cabinets.
Note:
Make sure that you do not turn on the power to the drive tray until this installation guide
instructs you to do so.
Procedure - Connecting the power cords
Steps
1. Make sure that the circuit breakers in the cabinet are turned off.
2. Make sure that both of the power switches on the drive trays are turned off.
3. Connect the primary power cords from the cabinet to the external power source.
Step 6 - Installing the drive trays for the controller-drive tray configurations | 83
Summary of Contents for E2760
Page 2: ......
