1
Front of the mounting rail
2
Two M5 screws for the rear EIA support rail
3
Front of the cabinet
4
Two M5 screws for the front EIA support rail
5
Adjustment screws
6
Rear hold-down screw
7
Cabinet mounting holes on the front EIA support rail
8
Cabinet mounting holes on the rear EIA support rail
9
Mounting rail lip
b. Remove the rear hold-down screw. It protrudes from the inside of the rail and prevents you
from sliding the drive tray onto the rails.
c. Place the mounting rail inside the cabinet, and extend the mounting rail until the flanges on
the mounting rail touch the inside of the cabinet.
Note:
If you are mounting the DE6600 drive tray in a cabinet with square holes, use the
square hole-to-round hold adapters in the rail kit to align the screws in the holes. The square
hole-to-round hold adapters are round washers with shallow shoulders that fit snugly into
the square holes in the rack.
d. Insert one M5 screw through the front of the cabinet, and screw it into the top captured nut in
the mounting rail.
e. Insert two M5 screws through the rear of the cabinet, and screw them into the captured nuts in
the rear flange in the mounting rail.
f. Counting up from the bottom of the mounting rail, place the bottom of the rear bracket in the
8th hole of the cabinet, so that the top of the rear bracket is in the 11th hole. The distance
between the two holes should be 1U or 4.45 cm (1.75 in).
g. Tighten the adjustment screws on the mounting rail.
h. Repeat these steps to install the second mounting rail.
76 | E2700 Controller-Drive Tray and Related Drive Trays Installation Guide
Summary of Contents for E2760
Page 2: ......
