Cable Connection
Chapter 3
INSTALLATION
48
Cable Connection
This section explains how to connect PC/Network Equipment with WL
Controller.
The following is an example using SCA-WL10.
Note.
WL Controller is activated with the default IP address “192.168.100.10/24”. The
following will be usually proceeded to set a WL Controller with initial setting.
1. Connect a PC with a WL Controller directly.
2. Modify an IP address.
For more information, refer to
“Connecting PC with WL Controller” on page 53
10BASE-T/100BASE-TX
(Straight cable)
Network Equipment (such as SW HUB)
Maintenance Console:
This is used to configure WL Controllers
and WL Access Points.
Connect to Ether1 Connector
Ether1
100M LINK
100M LINK
Ether2
PWR
ACT
ALM
LOAD
Front View
10BASE-T/100BASE-TX
(Cross-over cable)
Connect to an inlet
Stopper
(To fix AC power cable)
PACT
Rear View
Summary of Contents for WL1700-MS
