Data Assignment
Chapter 4
INITIAL SETUP
121
3
Assign an IP address to each interface.
Select
[Controller]
-
[Interfaces]
on the main menu. Click the
Edit
button to
display the Edit Interface screen, which can edit interface settings on the vlan
(default).
Specify the following items and click the
Apply
button. After the system has
restarted, if the different subnet is specified in the WL Controller, it is
required to change the maintenance console’s setting to be in the same
segment (subnet) with the Controller.
Note.
The data processing between WebView might be disconnected when interface
setting is modified. (An alert message will be indicated.) Reconnect to the modified
interface when WebView is disconnected.
Interface Setting
ITEMS
REMARKS
Admin Status
To assign an IP address per VLAN, select Enabled.
[Basic Setting : Select Enabled]
IP Address
Specify an IP address.
[Basic Setting : 192.168.10.10]
Subnet Mask
Specify a subnet mask.
[Basic Setting : 255.255.255.0]
Basic Settings
Summary of Contents for WL1700-MS
