Configuration Management
Chapter 6
SYSTEM MAINTENANCE
165
Example 1
) When copying the configuration file (file name: configuration) into
TFTP Server (192.168.0.1).
Note.
The procedures for backup can take the same result. For more information,
refer to “Backup” on page 168.
WL111111#
copy
configuration
tftp://
192.168.0.1
/
configuration
Ether1
100M LINK
100M LINK
Ether2
PWR
ACT
ALM
LOAD
Ether1
100M LINK
100M LINK
Ether2
PWR
ACT
ALM
LOAD
TFTP Server
192.168.0.1
Flash Card
TFTP
Running-Config
configuration
Copy configuration stored in flash card into TFTP Server.
GatoNegro
Simulator
copy configuration tftp://192.168.0.1/configuration
Note
:
When you modified the configuration, use the save config command to copy it into flash card.
And then proceed to the above. Otherwise, the modified data will not be copied into TFTP Server.
Summary of Contents for WL1700-MS
