Configuration Management
Chapter 6
SYSTEM MAINTENANCE
164
Copy
Use the Copy command to perform the following:
l
Back up data to TFTP Server
l
Restore data from TFTP Server
l
Duplicate data in Flash Card
In normal state, WL Controller is activated in the following way.
Ether1
100M LINK
100M LINK
Ether2
PWR
ACT
ALM
LOAD
Ether1
100M LINK
100M LINK
Ether2
PWR
ACT
ALM
LOAD
Ether1
100M LINK
100M LINK
Ether2
PWR
ACT
ALM
LOAD
Ether1
100M LINK
100M LINK
Ether2
PWR
ACT
ALM
LOAD
TFTP Server
Flash Card
TFTP
When system restarts,it reads configuration data saved
in flash card (default: configuration).
Running-Config
Running-Config
configuration
Note
:
The configuration file on Running-Config can be copied/overwritten to one in flash card by using the save
configuration command. For more information, refer to the Command Reference.
save configuration
GatoNegro
Simulator
Flash Card
Operation
configuration
Summary of Contents for WL1700-MS
