Data Assignment
Chapter 4
INITIAL SETUP
109
Setup Data Assignment Using WebView
This section describes data assignment for WL Controller and WL Access Points
by using WebView.
Before Doing This Task
When you perform data assignment using WebView, PC and Controller must be
connected directly. The following are network settings at initial state.
IP address: 192.168.100.10
Subnet address: 255.255.255.0
Be sure to cancel the proxy settings of Web Browser. And set the following
environment of Web Browser:
– Javascript: Enabled
– Cookie: Enabled
Assign the appropriate network settings to PC. Use a cross-over cable.
The following is an example when PC is connected to SCA-WL10. WL5100 is
also connected through Ether 1 connector.
10BASE-T/100BASE-TX
㧔
Cross-over Cable
㧕
Setup PC
Ether1
100M LINK
100M LINK
Ether2
PWR
ACT
ALM
LOAD
Front
㧨
Example of Network Settings
㧪
IP Address
㧦
192.168.100.11
Subnet Mask
㧦
255.255.255.0
Summary of Contents for WL1700-MS
