Data Assignment
Chapter 4
INITIAL SETUP
78
About CLI
The two types of the command mode exist in WL Controllers: Network Access
Mode and Administrative Access Mode. When you log in to a Controller, you
automatically enter Network Access Mode. To configure the Controller settings,
type
enable
to enter Administrative Access Mode.
As a default prompt, “WL + the last six digits of MAC address” is shown.
Explanation of each mode is as follows:
Note.
When the UNIVERGE WL Controller is in factory default state or after CLI
prompt changing, "*" appears at the head of the prompt until the prompt setting is
saved.
Table 2. CLI Command
Mode
Prompt
Explanation
Network Access Mode
>
A part of Config File can be displayed
by using show commands.
Administrative Access
Mode
#
Config file can be edited/deleted/
displayed by various commands.
Summary of Contents for WL1700-MS
