Access Point Installation
Chapter 3
INSTALLATION
62
Attaching APs to Ceiling (DrRP Ceiling Tiles)
This attachment requires 23.9mm (15/16 inch)-width T bar. This method also can
be done with 14.2mm (9/16 inch)-width and 15.9mm (5/8 inch)-width T bars.
Note.
The following steps are explained using WL1500-AP. In the case of installing
WL1700-MS, follow the same steps as explained below.
1
To attach an AP to ceiling, make holes in the appropriate parts of the ceiling
by using the mounting template.
2
Choose an appropriate T-type mounting bracket, which is suitable for T bar.
And then fit it to the T bar.
Mounting Template
UNIVERGE WL 1500-AP
Mounting Bracket
T-type Mounting Bracket
T Bar
T-type Mounting
Bracket
Slide it to match
the position.
Slide it to match
the position.
T Bar
T-type Mounting
Bracket
23.9mm(15/16inch)-width or
14.2mm(9/16inch)-width T bar
15.9mm(5/8inch)-width T bar
(Even if the clamp width is differet, the same
procedure will be taken.)
Summary of Contents for WL1700-MS
