Introduction
x
About This Device
Electric wiring for this device shall
always be interior circuit. Exterior
wiring may cause electric shock.
Do not insert fingers or metallic object,
such as a clip, into the ports. It may result
in electric shock and equipment failure.
Maintenance Precautions
When electric plug is kept plugged in for
too long, dust and moisture attaches to
the electric plug and AC socket, creating
a conductive path, leading to deterioration
in insulating material, which may result
in fire. Regularly clean out the electric
plug and AC sockets to remove dust. Also
occasionally check to see if the electric
plug is firmly plugged in.
Never remove the product cover. There are
high-voltage parts inside which may cause
electric shock. It may also result in fire,
and equipment failure. Contact the distributor
for cleaning and repairing the Product.
Do not use option boards and equipment
other than the ones specified. It may
result in fire, electric shock and
equipment failure. To prevent those from
occurring, take the following:
When turning on electricity for this Product,
wait at least 10 seconds after the power
lamp is off. Otherwise it may cause equipment
failure.
Warning for High Temperature
Interior parts, such as internal hard
disks are extremely hot immediately after
turning the power OFF. Install or remove
after the Product is adequately cooled off.
Use the standard electric codes in the
shipping countries(UL/VDE/Electrical
Safety Regulations).
Use insulation of class I for devices
and power codes to adjust them.
-
-
Summary of Contents for WL1700-MS
