Configuration Management
Chapter 6
SYSTEM MAINTENANCE
167
Configuration files are indicated after “file:”. Software image is indicated after “Boot:”
and log file or others are indicated after “temporary files:”.
Besides, when subdirectories exists under “file:” area, use
dir [directory name]
to list
the subdirectories.
(To display subdirectory “old”, type
dir old
.)
Besides, select an appropriate one of the configuration files saved in the Flash Card. A
file that actually used in booting is called boot configuration file. Use the following
commands to check the boot configuration file.
Using CLI
Use
show boot
.
In the command response, the file is indicated after “Booted Configuration File”.
Using WebView
Select
[Monitoring]
-
[Summary]
to display boot configuration file.
To change the boot configuration file, use
set boot configuration-file {file name}
.
The selected configuration file will be used when the system restarts. Type the show
boot command, and check to see the information is indicated after “Configured boot
configuration” in the command response.
Summary of Contents for WL1700-MS
