Data Assignment
Chapter 4
INITIAL SETUP
146
Data Assignment For Intelligent AP (Using Initial
Setup)
This section describes data assignment for WL Intelligent Access Points by using
Initial Setup tool.
Note.
This tool can be used on condition that WL1700-MS is in an initial state. If data
setting on the WL1700-MS have been changed from the initial state,
it is required to
return to the factory-set condition before data assignment
. For more information
about how to return to factory-set condition, refer to
“Return to factory-set condition”
When you assign data by using Initial Setup tool, the following are fixed. If you
want to assign data in details, refer to
“Setup Data Assignment Using CLI” on
or
“Setup Data Assignment Using WebView” on page 109
l
Radio settings are fixed to Auto RF.
l
Multiple VLANs cannot be created (fixed to VLAN1 only)
Summary of Contents for WL1700-MS
