Data Assignment
Chapter 4
INITIAL SETUP
151
Note.
When you specify a range of IP addresses by “Start IP Address” and “Stop IP
Address” (including an IP address for WL1700-MS), avoid overlapping IP addresses
already used in a network.
Note.
Same IP address of WL1700-MS must not be assigned for Internal AP of
WL1700-MS as well.
Enable Internal DHCP Server - This
controller will provide DHCP Services
to APs and wireless clients
If you want to use an internal DHCP
Server in WL1700-MS, select this box
and specify the following parameters.
Start IP Address
Create a DHCP scope (a collection of
IP addresses distributed to clients) by
specifying the Start IP Address and the
Stop IP Address.
Specifying either one (Start IP Address
/ Stop IP Address) is also available.
Stop IP Address
Enable DNS Server - This controller
will provide DNS Service to wireless
clients
If you want to use a DNS Server in
WL1700-MS, select this box and
specify the following parameters.
IP Address (Primary)
Specify an IP Address of primary DNS
Server
Domain Name
Specify a Domain Name
Table 5. Configure Basic System Information
PARAMETERS
REMARKS
Summary of Contents for WL1700-MS
