Introduction
viii
Using the Equipment Safely
Equipment
Do not touch the Product or electric plug
with wet hands. It may cause electric shock.
Never disassemble or alter the Project. It is
very dangerous and may result in fire, electric
shock and equipment failure.
Do not put other equipment on top of this
Product. Heat retention causes fire and
equipment failure.
Do not block the Product's ventilation duct.
Internal temperature rises, and may cause fire.
May cause personal injury,
system damage, or loss of data.
Incorrect use of the equipment may cause
electric shock.
Incorrect use of the equipment may cause
ignition.
White-out symbols indicate commands
and directions. (The left symbol indicates
ground connections.)
Indicates prohibited acts.
(The left symbol prohibits disassembly.)
WARNING
Incorrect use of the equipment may cause personal injury
or a serious system fault.
DANGER
Incorrect use of the equipment may cause personal injury
or death.
The following safety information describes
how to prevent danger and damage to
your properties.
ٟ
Safety Symbol
Learn the meaning of the following symbols
and then read this section carefully before
using the equipment.
Do not plug too many leads into a single
socket using branched plug sockets.
AC socket will overheat and may cause fire
and electric shock.
Insert sockets securely into the AC sockets.
Bad connection causes the electric plug and
socket to heat up. Metallic objects touching
the socket blades may cause fire and electric
shock.
Always hold the plug securely when disconnecting
from socket. Moreover, do not process, bend,
twist or pull the electric cords. Damage to the cords
may cause fire and electric shock.
ٟ
Precautions for use
DANGER
Electricity Source
Use the Product at AC100V-240V.
Never use at other power levels. Fires, electric
shock and system failure may result when used
at incorrect power levels.
Summary of Contents for WL1700-MS
