Configuration Management
Chapter 6
SYSTEM MAINTENANCE
166
Example 2
) Restore data (file name: newconfig) to WL Controller from TFTP
Server (192.168.0.1)
Note.
WL Controller can contain several configuration files and select one of them
when restarts.
To display the configuration files stored in the Flash Card, enter
dir
.
WL111111#
copy tftp://
192.168.0.1
/
newconfig newconfig
WL111111#
set boot configuration-file
newconfig
Ether1
100M LINK
100M LINK
Ether2
PWR
ACT
ALM
LOAD
Ether1
100M LINK
100M LINK
Ether2
PWR
ACT
ALM
LOAD
TFTP Server
192.168.0.1
Flash Card
TFTP
Running-Config
configuration
GatoNegro
Simulator
Copy a configuration file stored in TFTP Server into the flash card.
It cannot be overwritten to the configuration file stored in the flash card .
Note
:
copy tftp://192.168.0.1/newconfig newconfig
set boot configuration-file newconfig
When you want to use the configuration file copied from TFTP Server, restart the WL
Controller to apply the new configuration.
Summary of Contents for WL1700-MS
