Mounting
Chapter 3
INSTALLATION
44
2
Screw the right and left sides of SCA-WL10 to fix it.
Note.
For more information about mounting into 19-inch rack, refer to
Mounting Into 19-Inch Rack
The following explains the procedures for mounting into 19-inch rack.
l
Ask several installers to do this task for safety purposes.
l
Of rack mount brackets (attached on the front), the resistance to earthquakes
is 0.5G. It is also necessary to consider it on the rack side.
* To provide recommended racks with 1.1G, use optional mount brackets for rear
module [1U BRANCKET(E)]. The recommended racks are SV70 RACK (35U)
NR-581916-001 and SV70 RACK (39U) NR-581914-001.
1
Attach rack mount brackets (attached) to the right and left sides of WL
Controller. Use a Phillips driver to screw them.
Phillips driver
Ether1
100M
LINK
100M LINK
Ether2
PWR
ACT
ALM
LOAD
Summary of Contents for WL1700-MS
