NEC Univerge SV8100 VM8000 InMail, System Manual

Page: 205 / 388

VM8000 Issue 1.0
InMail System Guide 2 - 177
47-01-08 Delay in Dialing Digital Pager Callback Number (Pager Dial Delay)
Set the delay (0~99 seconds) that occurs just before VM8000 InMail dials
the Digital Pager Callback Number portion of the Message Notification
callout number for a digital pager. Set this delay so the pager service has
enough time to connect to the digital pager before sending the callback
number. Your pager service may be able to help you determine the best
value for this option (0~99 seconds). When placing a digital pager
notification, the system:
H
Seizes the trunk specified by the Trunk Group Routing setup.
H
Dials the user-entered notification number (in M OP + N).
H
Waits the 47-01-08 Delay in Dialing Digital Pager Callback Number interval.
H
Dials the number entered in 47-01-07 Digital Pager Callback Number.
The system assumes that the notification number completes dialing
approximately 4 seconds after trunk seizure. This means that, by default, the
Digital Pager Callback Number is
dialed into the pager service about 13
seconds after trunk seizure.
Your pager service may be able to help you determine the best value for
this option.
By default, this option is nine seconds.
2. Set up the system-wide options that apply to digital pager callouts.
47-01-09 Wait Between Digital Pager Callout Attempts (Notify Pager Intvl)
Set the minimum time (1~255 minutes) between unacknowledged or
unanswered digital pager Message Notification callouts. (A subscriber
acknowledges a digital pager notification by logging on to their mailbox.)
After this interval expires, VM8000 InMail tries the callout again (for up to
the number of times set in 47-01-14 Number of Callout Attempts).
If the system dials the callout number and the pager service is busy, it
retries the number in one minute.
By default, this option is 15 minutes.
47-01-15 Send Pager Callout Until Acknowledged (Retry Until Ack)
When this option is enabled (1), VM8000 InMail continues to retry a digital
pager Message Notification callout until the notification is acknowledged. If
this option is disabled (0), VM8000 InMail retries a digital pager Message
Notification the number of times specified in 47-01-14 Number of Callout
Attempts. This option does not apply to Message Notification callouts to
telephone numbers.
A digital pager notification is acknowledged when the recipient logs on to
the mailbox.
By default, this option is disabled (0).