NEC Univerge SV8100 VM8000 InMail, System Manual

Page: 103 / 388

VM8000 Issue 1.0
InMail System Guide 2 - 75
47-14-05 Screened Transfer Timeout (Scrn Trf Timeout)
Set how long a Screened Transfer from the Directory Dialing Mailbox will
ring an unanswered extension before recalling. The entries are 1~255
seconds or 0 for no recall.
By default, the Screened Transfer Timeout interval is 15 seconds.
6. To change the amount of time Directory Dialing callers have to dial letters:
47-14-06 Time Limit for Dialing Commands (Dialing Timeout)
Enter the new timeout duration (0~99 seconds).
If the caller waits too long to dial, the Directory Dialing Message repeats.
By default, Directory Dialing callers have 5 seconds to dial letters.
7. To record a Directory Dialing Message:
Refer to
Operation on page 2-77 .
The Directory Dialing Message is the Instruction Menu for the Call Routing Mail-
box programmed as a Directory Dialing Mailbox.
By default (without a custom message recorded), the Directory Dialing Message is,
“Please enter one or more letters of the person’s name, then press the pound key.”
47-01-04 Non-Subscriber Message Length (Mbox Msg Length)
This option sets the maximum message length (1~4095 seconds) for
Instruction Menus.
By default, this option is 120 seconds.
8. Enable or disable the ability of the Directory Dialing Mailbox to detect and route
incoming faxes.
47-14-07 Fax Detection (Fax Detection)
Enter 1 to enable Fax Detection; 0 to disable. If enabled, when the Directory
Dialing Mailbox detects incoming fax CNG tone, it routes the call to the fax
extension specified in 47-01-06 Fax Extension.
See Fax Detection on page 2-93 for more.
By default, Fax Detection is disabled (N).
9. Enable the Directory Dialing Mailbox caller to dial 0 for other options or # to
return to the Automated Attendant:
47-14-08 Next Call Routing Mailbox (Next CR Mbox)
Assign a Next Call Routing Mailbox (1~32) to the Directory Dialing Mailbox.
To remove an assignment, press Hold.
Once assigned, dialing # returns to the Automated Attendant. Dialing 0
follows the 0 action of the Next Call Routing Mailbox.
By default, there is no Next Call Routing Mailbox assigned.