Nautilus Hyosung MoniMax 5100T, Operator'S Manual

Page: 236 / 279

MoniMax 5100T 7. Appendix
7-
20
Error Code Cause Handling
4005100
Received a Inquire for over 121 notes
dispensing on the CDU from the upper
unit.
1. Check cash dispenser driver version (CDM SP)
4005200
Something is detected at the CS1AB
sensor before dispensing bills from first
cassette. (CS1AB Dark Detection)
1. Remove the remaining notes at a sensor in front
of the CST
2. Realign notes in the cassette
3. Check abnormal clutch.
4. Check abrasion of the cassette box pick unit.
4005300
Error for the double note detection during
separation.
4005400 Error in searching CS1 Sensor Table)
1. Initialize after resetting the power
2.Upgrade the CDU firmware or re-download
software
3. Replace the CDU B/D
4005500
CS13 sensor time out (Jam) during
dispensing bills.
1. Remove a jammed note between the tray and
CDU
2. Remove a jammed note at the position of the
CS13 sensor
3. Remove a dust on the CS13 sensor
4005600
Abnormal operation of the gate solenoid
during dispensing
1. Remove a jammed note on the gate
2. Remove notes in the reject box and remount the
reject box
3. Check if the CS3 sensor bracket is bended.
4. Check if the CS3 sensor cable is disconnected
(CN10 #9~10)
5. Exchange a sensor after abnormal operating
CS3 Gate detecting sensor.
6. Replace the reject solenoid 1
4005700 Cash dispenser configuration error
1. Replace cash dispenser PCB
2. Reconfigure cash dispenser setup data
4005800
Retract box position error during
command reserved operation
1. Mount the retract box or open the box cover
2. Check if CS62 sensor poll is abnormal
3. Check if the CS62 sensor cable is disconnected
(CDU Board CN10 #5~2).
4005900 Bill time out (jam) during initialization
1. Remove jammed notes
2.Clean the sensors (CS1~CS15) in cash dispenser
4005B00
2 Cassette Miss Feed Error (Fail to reject
bill separately.)
4005D00
Double bill detection error occurs 3 times
continuously during dispensing bills.
1. Check notes’ status in the reject box
2. Realign notes in the cassette
3. Check foreign objects at the position of the CS5
Sensor Guide
4. Check if the CS5 cable is disconnected
(CS5_1:CDU
B/D CN10 #11~12,
25~28//CS5_2:CN12)