Nautilus Hyosung MoniMax 5100T, Operator'S Manual

Page: 270 / 279

MoniMax 5100T 7. Appendix
7-
54
z
Physical Installation
To install the Model MoniMax 5100T ATM, perform the following steps.
1)
Height adjustor in this machine is the default type. Keep in mind that height adjustor and
wheel have the same hole location at the bottom. If you want to install the anchor bolt at
the installation site, place the
“
Anchor bolts locate sheet
”
at the place where the
machine is to be installed. (refer to Fig. 7.6)
2)
Place the system on a flat surface, the system has a tendency to tip over if the surface is
over 5 degrees. (refer to Fig 7.7) Be careful when opening the top or bottom of the
machine s it will be off balance
3)
Place the Anchor nuts into the ground according to the anchor bolts locate sheet.
(4 places)
4)
Place the Model MoniMax 5100T ATM on top of the sheet.
5)
Open the Security cover with the key provided.
6)
Using the supplied combination (factory preset at 50-25-50) open the Security Door.
This combination should be changed as soon as possible. Refer to Appendix B for
instructions on changing the lock combination.
7)
After the anchor nuts are in place according to the anchor holes on the bottom of
the MoniMax 5100T ATM, tighten the anchor bolts tightly.