User’s Guide – Osprey 75/102/130
Chapter 3: Basics
44
AP-75102, Rev. 2.0, 28/11/2007
3.2.2 Using the media core braces.
Media core braces are developed to prevent the media cores to bend while printing. This could cause bad print
quality or paper slant.
From the moment the core is larger than 2050 mm, we recommend installing the brace.
Do NOT install the
brace when the core is smaller than 2050 mm.
In the packaging box of the machine you will find two cores and two media core braces. There are already 3
spacers installed per brace with an outer diameter of 74 mm. In box 3/4 there are 6 spacers of 76 mm.
Please follow the instructions below to install and use the braces correctly.
Step 1 :
First check which spacer fits the best in the used core. If this one is not installed yet, remove the
installed one with a Hexagon Wrench 2 mm (in box 2/4) and install the correct one as shown below.
There is already a hole in the core in which the locking screw fits.
Step 2 :
Push the brace in the core. (Picture 1).
Be sure that the distance X is the same as Y (picture 2) and at least 75 mm.
No Description
1
Roll Unit
2
Positioning Cone
3
Media Core Brace
4
Spacer
5
Core of minimum 2050 mm
