User’s Guide – Osprey 75/102/130
Chapter 3: Basics
35
AP-75102, Rev. 2.0, 28/11/2007
Step 5 :
Lift the purge plate to make it operational.
Notes
•
The purge plate must be placed on the purge stand whenever the power is ON, except when head
cleaning is performed. Refer to: “Head cleaning”
•
If waste fluid comes into contact with the inside of the product, the product may malfunction.
Step 6 :
Close the maintenance cover.
Step 7 :
Press the [POWER] key on the control panel.
•
The POWER lamp on the control panel will light green.
•
The unit will initial start up operations.
•
The following message is displayed on the operation panel.
Notes
•
When switching ON the printer and the shelf life of a part comes to an end, the printer will notify it in
this stage of the start up sequence.
Notes
•
If there are any problems during the initial start-up operation, the unit will display a message on the
control panel, and the operation may stop.
•
If the operation stops, refer to "Troubleshooting", and take the appropriate measures.
Step 8 :
After confirming the removal of the print head cap, press the [ENTER] key on the operation panel.
Notes
•
After 3 seconds from the launch of the initial start-up operation, the initialization of the hard disk
installed in the unit is performed for about 10 seconds.
•
During this operation,
o
The operation panel will not work even if pushing the [ENTER] key.
o
The display will not change even if the parts’ life cycle is displayed.
