User’s Guide – Osprey 75/102/130
Chapter 3: Basics
52
AP-75102, Rev. 2.0, 28/11/2007
3.2.5 Setting media type
Be sure to read and understand the safety warnings before handling the printer.
Step 1 :
Switch ON the printer.
Notes
•
Before setting the media type, verify the media is correctly installed and loaded. Refer to: “Loading roll
media” to load media.
Step 2 :
Press the keys on the control panel to change the settings.
•
When changing the type of media: [F1] key
•
When changing the setting of the winding unit: [F2] key
•
When going over from media loading: [F3] key
•
When changing the setting of feed unit: [F4] key
Setup items
Key
Parameters
Descriptions
User 1
User 2
User 3
User 4
User 5
User 6
User 7
User 8
User 9
User 10
User 11
User 12
User 13
User 14
User 15
Media type
F1
User 16
Makes setting for media type used for test printing.
Sixteen settings of "User 1-16" can be set.
Refer to: “Menu setup on the operation panel”
Take-up OUT
Take-up IN
Take-up OUT/IN/OFF
F2
Take-up Off
Sets the operation of the winding unit.
•
Take up OUT: Set when taking up the printable side
•
outward
•
Take up IN: Set when taking up the printable side
•
inward
•
Take up Off: Set when not using the winding unit
Lever Up
Lever Up/Down
F3
Lever Down
Switches between up and down motion of the pressure
lever. Use this when starting over from the media setup.
Send Out
Send Out/In
F4
Send In
Sets the operation of the feed unit.
•
Send Out: Set when using the roll media such as the
printable side is outside
•
Send In: Set when using the roll media such as the
printable side is inside
Notes
•
Problems that occur due to usage of media with the printable side inside are not guaranteed.
