User’s Guide – Osprey 75/102/130
Chapter 7: Troubleshooting
169
AP-75102, Rev. 2.0, 28/11/2007
No.
Message
Solutions
References
1
Filling Ink
Wait for a while
The printer performs ink charging.
Please wait.
“Filling the ink - jet wash
fluid”
2
Purging
Wait for a while
The printer performs head cleaning.
Please wait.
“Head cleaning before
printing”
3
Initializing Paper
********
The printer performs initial setting of media.
Please wait.
(******** indicates the media type setting mode.)
“Setting media type”
4
Warming up
Wait for a while
The platen heater /ink drier is warming up.
Please wait.
–
5
Washing Head
Wait for a while
The print head is being cleaned for the cleaning
process of the long-term storage.
Please wait.
“Long-term storage
cleaning”
6
*Capping Out*
Remove Head Cap on
and press ENTER
The print head cap is attached. Remove the print
head cap, and press the [ENTER] key.
“Long-term storage
cleaning”
“Switching the power
ON/OFF”
7
*Manual Cut Paper*
Cut paper
and press ENTER
Cut the roll media, and press the [ENTER] key of
the control panel.
“Roll media cutting
procedure”
8
*Roller Turn*
Take up Roll -OFF-
can not operate
The winding unit is set to "OFF". Set to "ON" on
the winding unit menu.
“Menu setup on the
operation panel”
9 Discharging
JW
The jet wash fluid is being discharged the jet wash
fluid for the cleaning process of the log-term
storage or washing print head.
“Washing print head”
“Long-term storage
cleaning”
10 Injecting
Jetwash
The jet wash fluid is being injected the jet wash
fluid for the cleaning process of the log-term
storage or washing print head.
“Washing print head”
“Long-term storage
cleaning”
11 Power
OFF
The ink is being discharged into the print head cap
for the power OFF process.
“Switching the power
OFF”
12
*Cap Cover Set*
Put Cap Cover on
and press ENTER
Install the print head cap, and press the [ENTER]
key.
“Switching the power
OFF”
13
*Origin Pos. Check*
Confirm Position
and press ENTER
Waits to determine the setup values of the origin
setup menu. Press [ENTER] key on the operation
panel.
“Origin setup menu”
14
*Check Maintenance*
Motor [CR PF LV UD]
Motor [Takeup Send]
Head [KCcMmY]
There is the part that becomes end of the life
cycle.
•
Check the maintenance record menu.
•
Exchange the parts shown in the maintenance
record.
“Switching the power
ON”
See “Replacement of the
print head and CR motor”
15
*Purge End*
Print -> CANCEL
Purge -> ENTER.
The Purge process during printing is completed.
Press the following keys
on the operation panel:
•
When restart printing: [CANCEL] key
•
When continue purging: [ENTER] key
“Head cleaning before
printing”
