User’s Guide – Osprey 75/102/130
Chapter 3: Basics
49
AP-75102, Rev. 2.0, 28/11/2007
Step 12 :
If one edge of the roll media has been positioned 5 mm or less from the pressure roller’s end,
adjust the position of the roll media:
•
Release the right and left fixing levers of the feed units, and move the roll media to the left or
right.
•
After moving the roll media, fix it again with the fixing levers.
No. Name
1
Feed unit (Left)
2
Feed unit (Right)
3
Roll media
4
Fixing lever
Step 13 :
Press the [CANCEL] key on the operation panel.
•
The operation panel returns to the normal condition.
Notes
•
When using the winding unit, follow "Setting winding unit" and set the roll media to the winding unit.
Press the [F2] key on the control panel to lower the pressure roller.
•
The MEDIA SET lamp switches OFF.
Step 14 :
Close the front cover.
Step 15 :
Wait until the media initial menu is displayed on the control panel.
Notes
•
When changing the media type, follow “Setting media type" to set the media type.
Notes
•
If you load a new tube of roll media, the media end may not be straight. If so, cut the end of the roll
media. Refer to: "Roll media cutting procedure" to cut the roll media.
