User’s Guide – Osprey 75/102/130
Chapter 3: Basics
53
AP-75102, Rev. 2.0, 28/11/2007
Step 3 :
Press the [ENTER] key on the control panel.
•
The media type has been set.
•
The printer starts the media initialization.
Notes
•
In the media initial menu, the unit will move on to the media initial operation WITHOUT setting the
media type when :
o the [CANCEL] key of the control panel is pressed or
o Leaving the printer for 10 seconds without doing anything.
Step 4 :
Wait until the media initial operation has been finished and the printer is in normal status.
•
The media width is displayed on the operation panel for 5 seconds as shown below:
•
The setting media loading procedure has been completed.
3.2.6 Replacing roll media
Be sure to read and understand the safety warnings before handling the printer.
Replacement period
Replace roll media under the following conditions.
a. When the roll media loaded in the printer comes to an end
•
The following message is displayed on the operation panel.
•
If the media comes to an end while printing, the printer stops printing.
