Motorola HT 1000, User Manual

Page: 10 / 205

4
Assembling The
Hardware
The figure below shows how to assemble the required (and optional)
equipment used to program an HT 1000, JT1000 or VISAR radio.
Steps to Connect the
Hardware
1. Plug the 15-pin connector on the computer interface cable into
the RIB.
2. Connect the other end of the computer interface cable to the
asynchronous adapter on the computer. The RSS uses COM1 as the
default communications port. When both a serial port and a
modem are used, it is recommended that COM1 be used as a serial
port and COM2 be used for the modem. If COM1 cannot be used
for some reason, change the default to COM2 in the main SETUP
COMPUTER CONFIGURATION screen (
F9 ) and save it.
3. Plug the cable on the wall-mounted power supply into the RIB and
the other end into the wall outlet (optional).
4. Plug the 25-pin connector on the program/test cable to the RIB.
Connect the round 12-pin plug on the program/test cable to the
Portable Products Test Set (RTX-4005B). This is not necessary if
radio alignment will not be performed.
5. Connect the 13-pin plastic connector on the program/test cable to
the HT/JT1000 radio or the 9-pin connector to the VISAR radio as
the case may be.
30 dB PAD
TRANSMIT
RECEIVE
BNC
RF GENERATOR
SERVICE MONITOR
OR COUNTER
WATTMETER
AUDIO GENERATOR
SINAD METER
AC VOLTMETER
30 dB PAD
RADIO
PROGRAM/TEST CABLE
RKN-4035D (HT/JT1000)
TEST SET
RTX-4005B
TX
RX
RIB
RLN4008
data
busy
gnd
RVN-4098
(3-1/2 IN.)
COMPUTER INTERFACE CABLE
30-80369B71 (25 pin) or
30-80369B72 (9 pin)
RIB POWER SUPPLY
0180357A57 (120V) or
0180357A57 (220V) or
60-82728J01 (9V)
IBM PC (IBM PC and PS/2 compatible computer with MS-DOS version 3.1 or
asynchronous communications adapter and 512K of conventional mem
HT1000
SMA-BNC
58-80348B33
BATTERY ELIMINATOR
Replaces the battery pack
during servicing
P/N RLN-1014A (HT/JT1000)
P/N RLN-4327A (VISAR)
RKN-4042A (VISAR)
HT/JT1000/VISAR RSS