Mitsubishi FB13PNT, Quick Start Manual

Page: 5 / 292

iii iii
2. 2. How How to U to Use T se This his Man Manual ual
2. 2.1 1 Tr Truc uck Mo k Mode dell
(19) (19) Tighten connections to th Tighten connections to the correct torque e correct torque. Make sure . Make sure
that all heat shields, clamps and guards are installed that all heat shields, clamps and guards are installed
correctly to avoid excessive heat, vibration or rubbing
correctly to avoid excessive heat, vibration or rubbing
against other parts during operation. Shields that
against other parts during operation. Shields that
protect against oil spray onto hot
protect against oil spray onto hot exhaust components exhaust components
in event of a line, tube or seal failure, must be installed in event of a line, tube or seal failure, must be installed
correctly.
correctly.
(20) (20) Relieve all pressure Relieve all pressure in air, oil or water syste in air, oil or water systems before ms before
any lines, fittings or related items are disconnected or any lines, fittings or related items are disconnected or
removed.
removed.
Place blocks to prevent a device from falling if it is in
Place blocks to prevent a device from falling if it is in the the
raised position. Release the residual pressure when raised position. Release the residual pressure when
removing a pressurized device.
removing a pressurized device.
(21) (21) Do not operate a tru Do not operate a truck if any rotating part is damage ck if any rotating part is damaged d
or contacts any other part during operation. or contacts any other part during operation.
Any high speed rotating component that has been
Any high speed rotating component that has been
damaged or altered should be checked for balance
damaged or altered should be checked for balance
before reusing.
before reusing.
MC Truck (Manual Control System) MC Truck (Manual Control System)
Mechanically controlled hydraulic system (conventional Mechanically controlled hydraulic system (conventional
lever system)
lever system)
501489 501489
FC (Fingertip Control System) Truck FC (Fingertip Control System) Truck
This model allows a fingertip operation of lifting This model allows a fingertip operation of lifting and tilting and tilting
jobs, and ma jobs, and may improve y improve the job e the job efficiency with fficiency with less operatio less operation n
fatigue. fatigue.
501490 501490
Connector number Connector number
A connector number is allocated to each connector. A connector number is allocated to each connector.
Refer to the CHAPTER 5 CIRCUIT DIAGRAM or
Refer to the CHAPTER 5 CIRCUIT DIAGRAM or the connector the connector
number. number.