Mitsubishi Electric QJ71GF11-T2, User Manual

Page: 260 / 568

258
(1) Setting data
(a) Control data
The SREAD instruction control data is the same as that of the READ instruction ( Page 247, Section
10.4)
(b) Start device of the target station where data to be read is stored
The target station's start device where data to be read by the SREAD instruction is stored is the same as that of
the READ instruction. ( Page 247, Section 10.4)
(c) Start device of the own station where read data is stored
The start device of the own station where data read by the SREAD instruction is stored is the same as that of
the READ instruction. ( Page 247, Section 10.4)
Setting
data
Description Set by Data type
Jn
Own station's network No. (1 to 239, 254)
254: Network specified in Valid Module During Other Station Access
User
16-bit binary
Un
Start I/O number of the master/local module of the own station
(00 to FE
H
: Upper two digits of the I/O number expressed in three digits)
(S1) Start device of the own station where control data is stored
Device name
(S2) Start device of the target station where data to be read is stored
(D1)
Start device of the own station where read data is stored
A continuous area for the read data length is required.
System
(D2)
The device of the own station that turns on for one scan upon completion of
the instruction.
If the instruction fails, (D2)+1 also turns on.
Bit
(D3)
Device of the target station, which is turned on for 1 scan upon completion of
the instruction.
Data reading from another station can be confirmed.