Mitsubishi Electric PUHY-(E)P300, Service Handbook

Page: 40 / 302

[
II
Restrictions ]
31 - 31 -
HWE07010 GB
(4) Wiring method
1) Indoor/outdoor transmission line
Same as [5] 1.
Shielded cable connection
Same as [5] 1.
2) Transmission line for centralized control
No connection is required.
3) MA remote controller wiring
Same as [5] 1.
When 2 remote controllers are connected to the sys-
tem
Same as [5] 1.
Group operation of indoor units
Same as [5] 1.
4) LOSSNAY connection
Connect terminals M1 and M2 on the terminal block
(TB5) on the indoor unit (IC) to the appropriate terminals
on the terminal block (TB5) on LOSSNAY (LC). (Non-po-
larized 2-core cable)
Œ
Interlock setting between the indoor units and LOSS-
NAY units must be entered on the remote controller. (Re-
fer to "4 [3] Entering the Interlock Settings into the MA
Remote Controller" or the installation manual for the MA
remote controller for the setting method.)
5) Switch setting
Address setting is required as follows.
(5) Address setting method
The outdoor units in the same refrigerant circuit are automatically designated as OC, OS1, and OS2.
Proce-
dures
Unit or controller
Address
setting
range
Setting method Notes
Factory
setting
1 Indoor unit Main
unit IC 01 to 50 Assign the smallest ad-
dress to the main unit in the
group. To perform a group opera-
tion of indoor units that
have different functions,
set the indoor unit in the
group with the greatest
number of functions as the
main unit. 00
Sub unit Assign sequential numbers
starting with the address of
the main unit in the same
group +1. (Main unit ad-
dress +1, main unit ad-
dress +2, main unit
a3, etc.)
2 LOSSNAY LC 01 to 50 Assign an arbitrary but
unique address to each of
these units after assigning
an address to all indoor
units. None of these addresses
may overlap any of the in-
door unit addresses. 00
3 MA
remote con-
troller Main
remote
control-
ler MA No
settings re-
quired. - Main
Sub
remote
control-
ler MA Sub
remote
controller Settings to be made ac-
cording to the remote con-
troller function selection
4 Outdoor unit OC
OS1
OS2 51 to 100 Assign sequential address
to the outdoor units in the
same refrigerant circuit.
The outdoor units are auto-
matically designated as
OC, OS1, and OS2.(Note) To set the address to 100,
set it to 50. 00