Mitsubishi Electric GT14, User Manual, Page: 670 / 1546

31 - 34
31. FA TRANSPARENT FUNCTION
31.6 Personal Computer Side Setting
(4) Connecting the GOT and Ethernet adapter (NZ2GF-
ETB) in Ethernet connection, and connecting it to a
PLC in the CC-Link IE Field Network
This section describes the settings of GX Works2 in the
following case of system configuration.
POINT POINT POINT
Version of GX Works2
GX Works2 Version 1.34L or later is required to
execute the FA transparent function with using
Ethernet adapter (NZ2GF-ETB).
*1 Set the GOT network No. according to the third octet
(network No.) of the Ethernet adapter module IP address.
*2 The CC-Link IE field network master/local module is
mounted on slot 0 of the base unit.
The start I/O No. of the CC-Link IE field network master/local
module is set at [0].
10.
Specify the number for [Network No.] and [Station
No.] same as the number assigned to the Ethernet
module.
When [QnUDE(H)] is set for [PLC type], the setting is
not required.
11.
Specify the IP address assigned to the built-in
Ethernet port QCPU or Ethernet module for [IP
address].
12.
The screen returns to [Transfer Setup]. Click
to check if GX Developer has been
connected to the QCPU (Q mode).
Network No. :3
PC No. :1
IP address :192.168.3.18
Port No. :5001
Communication
format :UDP (fixed)
Ethernet
CC-Link IE Field Network
HUB
<Ethernet adapter unit>
(Use default value for settings other than the following.)
Ethernet setting
IP address
CC-Link IE Field Network setting
Network No.
Station No.
:192.168.3.30
:1
:1
<CC-Link IE Field Network master/local unit>
(Use default value for settings other than the following.)
Network Type
Network No.
PC No.
Total Stations
: CC IE Field (Master station)
: 1
: 0
: 2
<CC-Link IE Field Network master/local unit>
(Use default value for settings other than the following.)
Network Type
Network No.
PC No.
: CC IE Field (Local station)
: 1
: 2
<GOT>
(Use default value for settings other than the following.)