Minolta Di620, Manual, Page: 93 / 466

M-74
1155SBM1206A
12-6. Universal Tray (2nd Drawer) Paper Size Detection
●
The 2nd Drawer is a Universal Tray that automatically detects the size of the paper
loaded in it. Both the length (in the feeding direction) and width (in the crosswise
direction) of the paper are detected and the copier CPU determines the paper size
based on the combination of the two readings. The width of FLS and other sizes
(13" or 14" in the feeding direction) should, however, be set using the Tech. Rep.
Choice function.
●
The paper length (in the feeding direction) is detected by Paper Size Detecting
Switch which are actuated or deactuated by the lever moved in phase with the Trail-
ing Edge Stop.
●
The paper width (in the crosswise direction) is detected by 2nd Drawer Paper Size
Detecting Resistor mounted directly under the drawer, to the rear, beside the right
rail. The resistance of Detecting Resistor is varied as the rack of the Edge Guide
for the 2nd Drawer pushes the resistor.
= Size Detection in Feeding Direction =
= Side Detection in Crosswise Direction =
<Reference> To compensate for part-to-part variations of Detecting Resistor, be sure
to run the FD operation of “Function” available from the Tech. Rep.
mode whenever the Detecting Resistor has been replaced or removed
and reinstalled, or upon memory clear.
(S14/FD3)
(S12/FD1)
(S13/FD2)
1161M017AA
Paper Size Detecting Switch
2nd Drawer Paper Size
Detecting Resistor (VR2)
1161M018AA