Minolta Di620, Manual, Page: 244 / 466

T-29
Code Description Detection Timing
C0914 2nd Drawer Lift-Up Motor M25’s
failure to turn
<Metric Areas>
•
PC26 detects no HIGH-going or LOW-going edges
even after the lapse of 500 msec. after M25 has
started turning.
<Inch Areas>
•
PC26 detects no HIGH-going or LOW-going edges
even after the lapse of 500 msec. after M25 has
started turning forward (for upward motion) or back-
ward (for downward motion).
C0920 1st Drawer Lift-Up failure <Metric Areas>
•
1st Drawer Paper Lift-Up Sensor PC40 is not blocked
([L]) even after the lapse of 5 sec. after 1st Drawer Lift-
Up Motor M24 has started turning.
•
PC40 is not blocked ([L]) even when 1st Drawer Lift-
Up Motor Pulse Sensor PC25 detects 150 HIGH-going
and LOW-going edges after M24 has started turning.
<Inch Areas>
•
1st Drawer Paper Lift-Up Sensor PC40 is not blocked
([L]) even after the lapse of 5 sec. after 1st Drawer Lift-
Up Motor M24 has started turning forward (for upward
motion).
•
PC40 is not blocked ([L]) even when 1st Drawer Lift-
Up Motor Pulse Sensor PC25 detects 150 HIGH-going
and LOW-going edges after M24 has started turning
forward (for upward motion).
•
1st Drawer Lower Position Sensor PC18 is not blocked
([L]) even after the lapse of 5 sec. after M24 has
started turning backward (for downward motion).
•
PC18 is not blocked ([L]) even when PC25 detects 150
HIGH-going and LOW-going edges after M24 has
started turning backward (for downward motion).
•
PC18 is not unblocked ([H]) even after the lapse of 1.5
sec. after it has been blocked ([L]) while M24 is turning
backward (for downward motion).
•
PC18 is not blocked ([L]) even after the lapse of 5 sec.
while M24 is turning forward (for upward motion) after
the drawer has been unlocked.
•
PC18 is not unblocked ([H]) even after the lapse of 5
sec. after it has been blocked ([L]) while M24 is turning
forward (for upward motion) after the drawer has been
unlocked.
C0921
<Inch
Areas
Only>
1st Drawer lock release failure The 1st Drawer is not pushed out even after the lapse of
10 sec. after PC18 has been unblocked ([H]) while M24
is turning backward (for downward motion).
C0924 1st Drawer Lift-Up Motor M24’s fail-
ure to turn
<Metric Areas>
PC25 detects no HIGH-going or LOW-going edges even
after the lapse of 500 msec. after M24 has started turn-
ing.
<Inch Areas>
PC25 detects no HIGH-going or LOW-going edges even
after the lapse of 500 msec. after M24 has started turn-
ing forward (for upward motion) or backward (for down-
ward motion).