Minolta Di620, Manual, Page: 182 / 466

S-27
Tech. Rep. Mode Function
Touch Panel Display Operation
I.R. Mem. Prn
I.R.
➝
Memory: If a faulty image occurs, this function is run to check for cor-
rect image signal transfer and possible signal interruption
between the IR and memory, thereby identifying the defec-
tive block.
Note: The Touch Panel shows the percentage of processing completed of the
diagnostic sequence. If the sequence has been completed okay, it
gives the message of “OK”; if a fault was encountered, it gives the mes-
sage of “NG” together with the corresponding malfunction code
(C12XX).
<Procedure>
1. Touch [IR
➝
Memory].
2. Press the Start key to start the diagnostic sequence.
Note: The copier automatically stops as soon as it completes the diagnostic
sequence. The Stop key may, however, be pressed to halt the
sequence.
Memory
➝
Printer: If a faulty image occurs, this function is run to check for
correct image signal transfer and possible signal inter-
ruption between the memory and printer, thereby identi-
fying the defective block.
Note: The Touch Panel shows the percentage of processing completed of the
diagnostic sequence. If the sequence has been completed okay, it
gives the message of “OK” or the copier feeds out paper with a correct
image. If a fault was encountered, the panel gives the message of “NG”
and the corresponding malfunction code (C12XX, C13XX) or the copier
feeds out paper with a defective image.
<Procedure>
1. Touch either [Memory
➝
Prn1] or [Memory
➝
Prn2].
2. Press the Start key to start the diagnostic sequence. (The copier runs a
print cycle at the same time.)
3. Compare the image on the paper fed out with that of the sample to deter-
mine whether a problem exists.
Note 1: Use the Multi Bypass Table as the paper source.
Note 2: Load the Multi Bypass Table with A4 lengthwise or Letter lengthwise
paper.
Note 3: The copier automatically stops as soon as it completes the diagnostic
sequence. The Stop key may, however, be pressed to halt the
sequence. (The print cycle is completed with a single paper take-up
motion.)
Hard Disk Format This function formats the Hard Disk when it is connected for the first time or if
the Hard Disk develops a malfunction.
Note 1: Formatting the Hard Disk erases all data contained in it.
Note 2: The Touch Panel shows the percentage of processing completed. If
formatting has been normally completed, the panel gives the mes-
sage of “OK”; if it has been abnormally terminated, the panel gives
the message of “NG” together with the corresponding malfunction
code (C12XX).
<Procedure>
Press the Start key to start the formatting.
Note: The function is automatically terminated as soon as formatting is com-
pleted.
▼