Minolta Di620, Manual, Page: 234 / 466

T-20
<Fusing/Exit Misfeed Clearing Procedure>
Symptom Step Check Item Result Action
Paper is at a
stop before the
Fusing Roller. 1 Is the Fusing Guide Plate dirty or
deformed? YES Clean or change the Fusing
Guide Plate.
2 Check M14 for operation.
Does the voltage across PJ3A-7B on
PWB-A and GND change from DC0V
to DC3V when the Start key is
pressed? YES Check the Suction Belts and
change M14.
NO Change PWB-A.
Paper is at a
stop at the Fus-
ing Roller. 1 Are the Fusing Rollers dirty or
scratched? YES Clean or change the Fusing
Rollers.
2 Are the Fusing Roller Paper Separator
Fingers deformed, worn, or dirty? YES Clean, correct, or change
the Paper Separator Fin-
gers.
3 Is the Oil Roller dirty? YES Clean or change the Oil
Roller.
Paper is at a
stop in the exit
section. 1 Are the Exit/Duplex Switching Lever
and Transport Guide Plate dirty or
deformed? YES Clean or change the defec-
tive lever and/or guide plate.
2 Check SL3 for operation.
Does the voltage across PJ2A-14A on
PWB-A and GND change from
DC24V to DC0V when a copy cycle is
run using the Multi Bypass Table and
with special paper selected? YES Change SL3.
NO Change PWB-A.
3 Is S10 fully operational?
Make the input port check using “I/O
Check.” YES Change PWB-A.
NO Change S10.