Mindray SynoVent E5, Operator'S Manual

Page: 119 / 196

10-1
10
Cleaning and Disinfection
WARNING
 Obey applicable safety precautions.

Read the material safety data sheet for each cleaning agent.
 Read the operation and service instructions for all disinfection equipment.

Wear gloves and safety glasses. A damaged O
2
sensor can leak and cause burns
(contains potassium hydroxide).
 Reuse of undisinfected reusable accessories or components may cause
cross-contamination.
 To prevent leaks, avoid damaging any component in case of disassembling and
reassembling the breathing system. Ensure the correct installation of the system.
Make sure of the applicability and correctness of the cleaning and disinfection
methods.

Disassemble and reassemble the breathing system as described in this manual. For
further disassembly and reassembly, contact us. Improper disassembling and
reassembling may cause breathing system leak and compromise normal system use.

Seeping liquid into the control assembly can damage the equipment or cause
personal injury. When cleaning the housing, make sure that no liquid flows into the
control assemblies and always disconnect the equipment from the AC mains.
Reconnect the AC mains after the cleaned parts are fully dry.
 Do not use talc, zinc stearate, calcium carbonate, corn starch or equivalent
materials to prevent tackiness. These materials can go into the patient’s lungs and
airways and cause irritation or injury.
NOTE

Clean and disinfect the equipment as required before it is put into use for the first
time. Refer to this chapter for the cleaning and disinfection methods.
 To help prevent damage, refer to the manufacturer’s data if you have questions
about a cleaning agent.
 Do not use organic, halogenated, or petroleum based solvents, anesthetic agents,
glass cleaners, acetone, or other harsh cleaning agents.

Do not use abrasive cleaning agents (such as steel wool, silver polish or cleaner).
 Keep all liquids away from electronic parts.