3-31
1
1
3
Useful Function
5
6
Cut Out Data with Registration Mark
Detect operation
1
Scan in the B direction (plus direction) to detect
the line.
• The buzzer sounds when the line is detected. If the line is not
detected, the buzzer does not sound.
2
Scan in the B direction (minus direction) to detect
the line.
3
Scan in the A direction (plus direction) to detect
the line.
4
Scan in the A direction (minus direction) to detect
the line.
5
Follow the Steps 1 to 4, and confirm if the buzzer
sounds 4 times.
• When the detection behavior completes successfully, the
buzzer sounds 4 times.
• If the buzzer does not sound, contact our sales office after
checking the registration mark condition.
Correct the light pointer position
If the plotter fails to recognize any registration mark properly, the possible cause is an error in the positional
relationship between the MARK sensor and the light pointer.
In this case, adjust the position of the light pointer.
1
Install a cutter in the tool holder.
2
Load the copy paper.
Minus
direction
Plus
direction
Mark length
Scan in the A direction
Scan in the B direction
Minus
direction
Plus
direction
Summary of Contents for CG-100SRIII
