MIMAKI CG-100SRIII, Operation Manual

Page: 128 / 172

3-78
Function
name
Outline Setting values
Jog Step
This is to set the moving amount of
carriage and sheet via the jog key.
0.1mm
(set in mm)
0.1mm movement per jog key operation
1.0mm
(set in mm)
1.0mm movement per jog key operation
1/16inch
(set in inch)
1/16inch movement per jog key operation
1 / 2 5 4 i n c h
(set in inch)
1/254inch movement per jog key operation
mm/inch
This is to select the unit with which
you want to display the length.
mm This is to display in mm.
inch This is to display in inch.
Feed
Option
Feed
Offset
Regarding AUTO FEED,
this is to add the offset value
to feed a little bit longer.
0 to 100cm See P.3-57.
Feed Speed Set the speed of feeding. 1 to 30cm/s See P.3-58.
Pre Feed
Feed Count OFF, 1 to 5
Performs the setting for automatic feeding
after sheet detection and automatic cutting.
（
P.3-59
）
Feed Length
0.1 to 5m
Feed Wait 0 to 90 sec
Over Feed
ON/OFF
Dummy
cutting
When this is set to “ON,” the blade
edge is made to turn to a specific
direction before starting cutting, which
allows dummy cutting.
ON
This is to perform dummy cutting every
time the tool and cutting conditions are
changed.
OFF This is not to perform dummy cutting.
Sheet set-
ting This is to set the types of sheet
according to the sheet you use.
Standard
This is to be set when you use the regular
sheet.
Heavy
This is to be set when you use heavier
sheet than the regular one.
(The maximum cut speed setting is limited to
20 cm/s and it moves at 20 cm/s even if the
up-speed setting is set at 20 cm/s or more.)
Sorting
This setting changes the cutting order
and performs cutting.
See P.3-44.
Compen-
sated pres-
sure offset This is used to expand the value in
such a case as when the beginning
and end part of the cut are left cut.
±9 Around -30g to around 30g
Pinch Roll Select the number of pinch roller to use. See P.3-61.
Over Cut
Make the media without uncut area.
See P.3-54.
Start
Mode
Set the mode after detecting the sheet.
LCL
The mode switches to the standby condition
of the local mode after detecting the sheet.
REM
The mode automatically switches to the
remote mode after detecting the sheet.
P R E S S
COMP.
Corrects variations in cutting pressure due to
position in order to provide uniform cutting ability.
ON Enables the function.
OFF Disables the function
Search
Mark
Set the automatic registration mark
search function performed after the
sheet is detected.
See P.3-27.
Pen Set-
ting
D o w n
Speed
Set the pen down speed. 0 to 20 to 64
The bigger the numerical value is, the faster
the down speed becomes.
*1
*1. For the thick sheet of 1mm and more, if the down speed is too fast, the machine may drag the pen tip. In such a case, set the down
speed to “20” and less.
C u r v e
Mode
*2
*2. Use the “SLOW” setting to correct curved lines if they become twisted.
Set the drawing speed of curved lines.
FAST The standard mode.
SLOW Reduces the drawing speed of curved lines.