3-81
1
1
3
Useful Function
5
6
Miscellaneous Settings
Command Switching
• Changing the setting value will clear the data in the receiver buffer.
• With a large size of data, the [AUTO] mode may not function normally. In that case, change the setting to MGL -
Ic1 or MGL-IIc.
• Once the plotter receives data from the computer with [AUTO] selected, the display panel indicates the
recognized command and the plotter stars cutting. The display panel may continue indicating a command name
or display [ERR16 UTO I/F] if the command cannot be recognized automatically. In such a case, change the
command setting to MGL-I c1 or the MGL- IIc to perform normal cutting.
• The recognized command by [AUTO] will be effective until the data clear (
P.3-48) is executed or sheet
setting is performed again.
Cutting Mode
Select “QUALITY” in any of the following cases:
• Characters whose sizes are 10 mm or less are to be cut
• Picture patterns or characters that have many sharp corners are to be cut
• Minute cutting is to be performed
However, the edges of finished patterns may be rugged if the data sent from the host computer is too
complicated. In such a case, select “HIGHspd” for smooth finish.
Origin Switching
When the ROTATION function is ON, the origin is as follows:
• Setting the command origin point to the [LOWERrightORIGIN] when using a roll sheet will expand the
cutting area up to 51 m.
• The cutting area is 5 m if the command origin is set to [CENTER ORIGIN] when using a roll sheet .
Rotation : OFF
Rotation : ON
LOWER right ORIGIN
CENTER ORIGIN
Command origin
LOWER right ORIGIN
CENTER ORIGIN
Summary of Contents for CG-100SRIII
