2-16
Setting a leaf sheet (cut sheet)
1
Press the
key to switch to NOT READY
mode.
• You need not to do so if it ia already in the NOT READY mode.
Start operation from the Step 2.
2
Load the leaf sheet on the platen.
(1)
Move down the clamp lever to the rear and raise the
pinch rollers.
(2)
Set the right end of the sheet considering the platen
vertical rib as the measure.
Or, align the near end of the sheet in parallel with the
platen.
3
Move the pinch rollers fitting to a width of the sheet.
• Locate each of the pinch rollers 5 mm or more inside the sheet
edge; otherwise, the sheet can slip off the pinch rollers while it
is being fed.
4
Move down the clamp lever to the front and move
the pinch rollers down.
5
Press the jog key
or
to select “LEAF”.
• For “Sheet detection” (
P.2-14)
•
: In the case the sheet is loaded from the rear
: In the case the sheet is loaded from the front
• When you press the
key, the screen to select the number of pinch rollers is
displayed before sheet detection. After selecting the pinch roller, sheet detection is
performed.
• The number of pinch rollers set here has priority over the one selected from [SET UP] -
PINCH ROLL.] menu.
SHEET SET
Vertical rib
FEED
Summary of Contents for CG-100SRIII
