3-21
1
1
3
Useful Function
5
6
Cut Out Data with Registration Mark
Method of detecting registration marks
Registration marks are detected in two different ways; full-automatic detection and semi-automatic detection.
Use the semi-automatic function when the TP1 is not located at the bottom right of the sheet, or when the
supplied FineCut is to be used as the cutting software.
Check sheet skew with a light pointer
Move down the clamp lever to the front
and
then the Light Pointer is turned lit. You can manually move the
carriage to the left and right.
Move down the clamp lever to the front
, and manually move the carriage between the registrations TP1 and
TP3. Then you can confirm the sheet inclination by the move line of Light Pointer. Align to the move line and
adjust the sheet inclination.
Full-automatic detection of marks
Use this function to correct the error in the detected length between registration marks as compared with the
printed length between registration marks. For this purpose, measure the length A and B on the data beforehand.
Measure the length between the registration marks.
• If the sheet is curled, straighten it.
• When using a cutting software having no mark function, use a sheet which has neither stains nor images
in the area (A) located between TP1 and TP2 and in the area (B) located between TP1 and TP3.
• If no operation is performed for five minutes, the light pointer will automatically go out.
Moving line of
the light pointer
Sheet skew
Mark: Type 1
Mark: Type 2
Summary of Contents for CG-100SRIII
