3-5
1
1
3
Useful Function
5
6
Functions in the Jog Mode
Digitization operation
The coordinates of the plotted figure relative to the origin are displayed on the host computer.
Upon receiving the digitization command (DP;) from the host computer, the plotter is ready for digitization
operation.
To conduct digitization, install a sheet with patterns to select points on it.
1
Set the plotter in the remote mode and make it receive
the digitization command from the host computer.
• The display will change as shown at right.
2
Move the pen with a jog key
or
until the pen tip reaches a given point of the pattern.
• The coordinates relative to the origin will be displayed.
• If you set the step to a smaller value using the jog step function, you
may select a desired point with increased accuracy. (
P.3-78
)
3
Press the
key.
• The plotter records the point of the pen head.
• The plotter receives the coordinate output command (OD;) from
the host computer.
• The digitization operation is available only with an application software that incorporates a digitization
function. Refer to the instruction manual for the application software for how to use the digitization
function.
ENTER/HOLD
Summary of Contents for CG-100SRIII
