4-4
Troubles for which error messages are given on the LCD
Error message
Error messages are shown as error numbers.
Take an appropriate remedy according to the table below. And if the remedy does not work, contact your
distributer or an sales office of MIMAKI.
Error message
Cause
Remedy
ERROR C02
MAIN RAM
Trouble has occurred in the control RAM.
Contact your dealer or a sales office of
MIMAKI.
ERROR C04
EEPROM
Trouble has occurred in the system ROM.
ERROR C06
BUFFER
Trouble has occurred in the receiver
buffer.
ERROR C08
POWER
Trouble related to the motor has occurred.
ERROR C10
COMMAND
Code other than command data has been
received.
Check the command setting on the host
computer.
ERROR C11
PARAMETER
A parameter outside the numerical range
has been received.
Check the parameter.
ERROR C12
DEVICE
The plotter received an improper device
control command.
Check the command setting on the host
computer.
ERROR C13
PM OVER
Data on polygon has overflown the
polygon buffer.
Change the setting so that the polygon
command is not used or the MGL-lc1
command is to be used.
ERROR C15
AUTO FEED
The plotter has failed to feed the sheet by
the length specified by the ZX command.
After completion of sending the data from
the host computer, reload the long sheet
and execute the plural sheets cutting.
During division cutting, the plotter has
failed to feed the sheet for cutting based
on the second and ubsequent data by the
same length as for the first cutting.
Load a longer sheet on the plotter and set
the remote mode again.
ERROR C16
AUTO I/F
The plotter has failed to detect a
command automatically.
Set the command name.
(
P.3-77
)
ERROR C20
I/O
The communication condition is different.
Make the communication condition same
as that of the host computer side.
(
P.3-77
)
ERROR C27
BUFFERover
The interface is faulty.
Check the interface cable.
ERROR 901
OPERATION
An invalid operation was performed on
the control panel.
Refer to the relevant page of operation
manual for valid operations.
ERROR C31
NO DATA
The plotter started the plural sheets
cutting but found that there is no data in
the receiver buffer.
Refer to the explanation of the plural
sheets cutting function.(
P.3-9
)
ERROR C32
DATAtooBIG
The amount of received data is too large
for the plotter to perform the plural sheets
cutting.
ERROR C33
SHEET SIZE
The sheet is too short in the feeding
direction.
Use a longer sheet.
ERROR 902
DAT REMAIN
The plotter executed an improper
operation during a halt.
Press the
key to cut the
remaining data or execute data clear if
there is no need of using the data in the
receiver buffer.(
P.3-48
)
ERROR 41b
∗∗
NO MEDIA
∗∗
You performed the operation that
becomes valid after sheet detection.
Perform sheet detection.
REMOTE
Summary of Contents for CG-100SRIII
