1
1
3
Useful Function
5
6
3-47
Other Useful Functions
Feed the paper
Before starting cutting (plotting), feed the sheet manually by the
length to be used.
In addition, by feeding the sheet beforehand, you can check for a
skew of the sheet or prevent skew
while cutting (plotting) the long data.
1
Press the
key in the local mode.
2
Press the jog key
or
to select [FEED]
.
3
Press the
key.
4
Input the feed amount using the jog key
or
.
•
Setting value
In “mm”
: 0.1 m to 51.0 m (in increments of 0.1 m)
In “inch” : 1 to 167 feet (in increments of 1 ft.)
5
Press the
key.
• Pull out an amount equal to the feed offset amount (
P.3-57) added
to the input length.
• If you start the plotter for high-speed cutting without
feeding the leading edge of the roll sheet by some length
beforehand, there may be a case where the feeding the
sheet is not started and thus the plotter goes into an
error state.
• Feed function does not work until the sheet is detected.
• To interrupt the sheet feeding, press the
key.
• If the sheet length is shorter than the set value, feeding is performed
with the sheet that was pulled out.
FUNCTION
ENTER/HOLD
ENTER/HOLD
END
Summary of Contents for CG-100SRIII
