5-4
Cutter blade
Replacing the cutter
If the cutter is chipped or blunt, replace it with a new one. (Accessorry parts number: SPA-0030)
New cutter (low-pressure blade set for PVC sheets: Model SPB-0030) are available from your distributor or
MIMAKI's sales office.
1
Remove the cap located at the edge by rotating it.
2
Replace the cutter with a new one using tweezers or
the like.
Adjusting the cutter blade
After adjusting the blade edge, set the cut condition and perform test cut to check whether cutting is performed
well.
1
Turn the adjusting knob to adjust the protruding
amount of the cutter.
• arrow to protrude the cutter blade.
( 0.5 mm per revolution)
• The cutter blade is sharp. Keep your fingers away from the cutter.
• Do not shake or swing the cutter holder; otherwise, the cutter blade may come off, which is
dangerous.
• Keep the cutter out of reach of children. Dispose of the used cutter blade in compliance with the
applicable regulations.
Name of product
Product No.
Specifications
Remarks
Decentering
blade for vinyl sheet
SPB-0001
Package of three pieces of blades
Decentering
blade for small letters
SPB-0003
Package of three pieces of blades
Decentering
blade for rubber sheet
SPB-0005
Package of three pieces of blades
Decentering
blade for reflecting sheet
SPB-0006
Package of two pieces of blades
Decentering
blade for fluorescent sheet
SPB-0007
Package of three pieces of blades
Replacing the cutter other than supplied
one
SPB-0030
Package of three pieces of blades
supplied one
Decentering
blade for thick rubber sheet
SPB-0084
Package of three pieces of blades
Cutter holder
Cutter
Cap
Cutter
Adjusting knob
Summary of Contents for CG-100SRIII
