MIMAKI CG-100SRIII, Operation Manual

Page: 141 / 172

Troubles for which error messages are given on the LCD
4-5
1
1
1
4
In Case of T
rouble
Error message Cause Remedy
ERROR C36
MARKdetect
No registration mark was detected.
Check the sheet for curling.
Check to see if the starting point to detect
the registration mark has been set properly.
(
P.3-21 )
Check to see if the black registration mark
is printed against the white background.
Check to see if there is no dust or dirt
between the registration marks.
Check to see if there is no mistake in
registration mark settings. (
P.3-16 )
Confirm the status and the settings
described above. If still no registration
mark is detected, contact your distributor or
a sales office of MIMAKI.
Set the “MARK FILL UP” of registration
mark detection to “ON” when filled in
around the registration mark.
(
P.3-20
)
ERROR C37
MARK ORG
The origin point was detected outside the
cutting area. Arrange the registration marks inside the
sheet.
ERROR C38
MARK SCALE
Registration mark detection was not
achieved. However, this error is
attributable to a false detection or a
compensation value setting error, since
the calculated compensation value is
wrong.
Correct the compensation value if it is
wrong, and perform detection again.
The required scale compensation value
was not smaller than 1.3 times or not
greater than 0.7 times. Remove the cause of the detection error,
for example, correct the blurred print of
registration mark data and then retry.
A detection error occurred since the
distance from the adjacent graphics was
too short. Increase the distance from the adjacent
graphics properly, and perform printing
again.
The designateed spacing between the
registration marks is not correct.
The value of the spacing between the
registration marks designated by the
command is wrong and it is attributable to a
selection error of data. Therefore, check
the output data.
The print is not uniform and some
graphics are omitted. Correct the graphic data to obtain uniform
print and perform printing again.
As the printed registration mark was
blurred, it was not read correctly and the
registration mark of the next graphics was
read by mistake.
Perform printing again with care that the
print is not blurred.