3-4
Cutting area
Set the area in which the plotter performs cutting (plotting).
The area that has a diagonal line extending from the origin
to a given UL (upper left) point is the available cutting area.
The cutting area setting will be cleared by performing sheet
detection again.
1
Press the
key to set to the local mode.
• Confirm in advance that even if you press the
key to enter
the remote mode, the plotter does not perform cutting (plotting).
2
Press the jog key
,
,
or
to enter
the jog mode.
• Press either one of the jog keys, and you can enter the jog mode.
3
Press the
key.
4
Press the jog key
,
,
or
to set
the point UL.
5
Press the
key to decide the point UL.
• The display is as shown on the right briefly, after which the plotter
returns to the local mode.
• Be sure to set the upper left point in the area located in the normal direction from the origin.
• Be sure to set the origin in the cutting area. If the origin is located outside the cutting area, the plotter
will go into an error state.
Point UL
Origin
Available cutting
area
REMOTE
REMOTE
FEED
ENTER/HOLD
Summary of Contents for CG-100SRIII
