3-48
HOLD
If a sheet goes out of alignment while long data is being cut
(picture-drawn), you can temporarily hold the cut for fixing the
misalignment of the sheet.
1
Press the
key during data cutting.
• Press the
key between figures. If you press it in the middle
of the line, the cut line does not match each other.
2
Fix the sheet misalignment.
(1)
Move down the clamp lever to the rear.
(2)
Fix the sheet misalignment.
(3)
Move down the clamp lever to the front.
(4)
Press the
key.
3
Press the
key to restart cutting.
DATA CLEAR - Discontinue Plotting -
Execute the DATA CLEAR function to discontinue cutting (plotting) for data.
If you do not perform DATA CLEAR, the plotter will perform cutting for the received data when it is returned to
the remote mode.
Once DATA CLEAR is executed, the plotter will perform cutting (plotting) for new data, if received after the
plotter is set to the remote mode.
1
Press the
key during data cutting.
2
Press the
key.
3
Press the
key.
• When correcting the displacement of the sheet, move
neither the carriage nor the pinch rollers. If they are
moved out of position, a damage to the device or an
error will arise.
• The
key does not work until the sheet is detected.
• In the local mode, hold down the
key for approximately 2.5 seconds.
• Do not perform DATA CLEAR while the host computer is sending data.
• Even after execution of DATA CLEAR, the received data remains in the receiver buffer. Cutting
(plotting) can be repeated by the No. COPIES function.
Data after the correction
of sheet displacement
Cut before the sheet
misalignment is fixed.
ENTER/HOLD
ENTER/HOLD
END
REMOTE
ENTER/HOLD
ENTER/HOLD
REMOTE
FUNCTION
ENTER/HOLD
Summary of Contents for CG-100SRIII
