Other Useful Functions
1
1
3
Useful Function
5
6
3-57
Setting the FEED OFFSET
You can perform extra feeding when feeding sheets by pre-feed or similar method.
By performing extra feeding, you can ensure slack required for cutting (plotting).
1
Press the
key in LOCAL mode.
2
Press the jog key
or
to select [SET UP].
3
Press the
key.
4
Press the jog key
or
to select [FEED
OPTION] .
5
Press the
key.
6
Press the
key.
7
Press the jog key
or
to select the offset
value.
•
Setting value
: 0 to 100cm
8
Press the
key.
9
Press the
key several times to end the setting.
• When the remaining amount of the roll sheet is less, sheet rewind may occur due to shaking during
operation, and lack of sheet slack may occur. It may cause incorrect cutting (plotting). However, using
this function, you can reduce this problem.
• The set value is retained even when the power is turned "OFF".
• When over feeding is set, the setting of feed offset becomes “invalid”.
FUNCTION
ENTER/HOLD
ENTER/HOLD
ENTER/HOLD
ENTER/HOLD
END
Summary of Contents for CG-100SRIII
